# INSTALLATION INSTRUCTIONS



# INSTRUCTION STEPS

### <span style="color: rgb(53, 152, 219);">1. **Make sure you make communications with your supervisor before to start of any task New installation/Service**</span>

### <span style="color: rgb(53, 152, 219);">**2.Make sure you get payments proof or any information from your leader. or authorization from your leader.**</span>

### <span style="color: rgb(53, 152, 219);">**3.Make sure you make prior communications with customer immediately, to let him/her know your availability and your mobile no for further communication.**</span>

### <span style="color: rgb(53, 152, 219);">**4.Before The installation/service start make sure that you take 3 types of photos from vehicles (Front photo, Side photo and Back photo).**</span>

### <span style="color: rgb(53, 152, 219);">**5.Make sure you get correct mobile no for bus owner and person in charge.**</span>

### <span style="color: rgb(53, 152, 219);">**6.Make vehicle inspection before and after installation with collaboration with bus owner/person in charge to ensure all vehicle accessories are working well and all not working note down.**</span>

### <span style="color: rgb(53, 152, 219);">**7.Find and select secure place to install GPS device and that place make sure no other electronics device installed and no possibility of water or oil spilling.**</span>

### <span style="color: rgb(53, 152, 219);">**8.Take photo of GPS device to show (Device Serial &amp; imei number, open inside also the device imei number hardcoded in the circuit)**</span>

### <span style="color: rgb(53, 152, 219);">**9.Make sure the simcard is connected properly in the device**</span>

### <span style="color: rgb(53, 152, 219);">**10.Make sure the internal battery is connected in the device properly.**</span>

### <span style="color: rgb(53, 152, 219);">**11.Then Start device installation to the vehicle and installation location should approved by Supervisor.**</span>

### <span style="color: rgb(53, 152, 219);">**12.After correct installation make sure the installed device transmitted current data to our internal platform(tracking.ictpack.net) or approved by your supervisor device transmitted data is okay**</span>

### <span style="color: rgb(53, 152, 219);">**13.Conduct Vehicle test to ensure the device start alarm at the required speed threshold start or above (80Km/h)**</span>

### <span style="color: rgb(53, 152, 219);">**14.Ensure Jobcard is filled with correct customer information, to avoid errors use CAPS Type.**</span>

### <span style="color: rgb(53, 152, 219);">**15.Ensure Contract Signing for new installation and share photo of last signed page together with your installation photos.**</span>